Rp 13,500
Min.Order : 1
Code: MSDM230217
Items:
1x Module
Micro SD Card Module Mini TF Card Read and Write 6pin (T0024)
1. Support Micro SD and SDHC card (high-speed card)
2. The level conversion circuit board interface level is 5V or 3.3V
3. Power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board
4. Communication interface is a standard SPI interface
5. 4 M2 screw positioning holes for easy installation
6. Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin
7. 3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SD card supply
8. Level conversion circuit: Micro SD card into the direction of signals into 3.3V, MicroSD card toward the direction of the control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal
9. Micro SD card connector: yes for easy card insertion and removal
10. Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, the module is easy to install positioning, to achieve inter-module combination
1. Support Micro SD and SDHC card (high-speed card)
2. The level conversion circuit board interface level is 5V or 3.3V
3. Power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board
4. Communication interface is a standard SPI interface
5. 4 M2 screw positioning holes for easy installation
6. Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin
7. 3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SD card supply
8. Level conversion circuit: Micro SD card into the direction of signals into 3.3V, MicroSD card toward the direction of the control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal
9. Micro SD card connector: yes for easy card insertion and removal
10. Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, the module is easy to install positioning, to achieve inter-module combination
Berat:15 gr